SR Enviro Engineering designs, engineers and manufactures air pollution control and process handling systems for industrial plants across India — from bag filters to full flue gas desulphurisation lines.
We are one of India's established names in the design, engineering and manufacturing of air pollution control systems, dust collection systems, flue gas desulphurisation, and material handling equipment for industrial plants.
Every system we build — from a single knife gate valve to a complete wet ESP installation — is engineered around the actual process conditions of the plant it serves: dust load, gas temperature, moisture, and duty cycle, not a standard datasheet.
Equipment sized against your actual dust load and gas chemistry, not a generic spec sheet.
Design, fabrication, and field spares under one roof — one point of accountability.
Boilers and boiler spares handled alongside the pollution control equipment they feed.
Systems built to slot into existing plant layouts and ducting, not just greenfield sites.
Air pollution control equipment, gas cleaning systems, and the material handling components that support them — designed and manufactured to fit your process line.
High-efficiency fabric filtration for fine particulate capture across dusty process streams.
Wet electrostatic precipitators for sub-micron particulate and mist removal at high efficiency.
Gas absorption and particulate scrubbing systems for acid gas and dust-laden exhaust streams.
FGD systems engineered to bring SO₂ emissions within regulatory limits for boiler and kiln plants.
Centrifugal pre-separation for coarse particulate, reducing load on downstream filtration.
Moisture-reduction systems sized for consistent throughput on variable biomass feedstock.
Bulk material conveying for ash, dust, and process by-products with abrasion-resistant construction.
Continuous material discharge under pressure differential, sealed against air ingress.
Wets and conditions dry ash for safe, dust-free handling and disposal, in any capacity required.
Process air and gas movement engineered against your system resistance curve.
Axial and centrifugal fans for ventilation, draft, and process gas handling duties.
Isolation and flow-control valves for slurry, ash, and bulk powder lines.
Gas flow control and isolation for ducting across pollution control and process lines.
Boiler units and a full range of spares, supplied and supported alongside your emissions systems.
Complete capture-to-discharge dust systems, engineered around your specific process layout.
A project moves through four stages, with our engineering team involved at each one — not handed off after the drawing is signed.
We assess dust load, gas volume, temperature, and existing layout before any sizing begins.
Equipment is engineered and drawn against your specific operating conditions, not a stock model.
Built in-house under our own quality checks, with material traceability at every stage.
Our team supports installation and start-up on site, and stays on for spares and service after.
Share your process details — gas volume, dust load, existing layout — and our engineering team will get back with a recommendation and quote.